Running a heater off a 20 lb tank, hose and filter included
A 20 lb tank outside the shelter fixes the biggest weakness of a Buddy heater, the small cylinder that fades in deep cold. It also brings a hose through the wall, which needs the right parts and a few good habits.
Why anglers move to a 20 lb tank
Each Buddy manual warns that steady use below 20 °F cuts run time hard, and every hose-ready model’s manual recommends a 20 lb tank instead. A small cylinder can’t turn liquid into gas fast enough in the cold, so it frosts over and the flame sags.
A big tank holds far more liquid to boil from, so it keeps up where a 1 lb cylinder gives in. The guide to propane in the cold explains the vapor-pressure side in more detail.
The other reason is plain fuel. A 20 lb tank holds about 432,000 BTU of propane (20 lb times roughly 21,600 BTU per pound), against about 22,100 BTU in a 1 lb cylinder.
What the manuals say about run time
Mr. Heater gives these run times on one 20 lb tank, from the high setting to the low one. They are maker figures for steady use, so a windy, bitter day will land nearer the short end.
| Heater | Remote tank option | One 20 lb tank | One 1 lb cylinder |
|---|---|---|---|
| Portable Buddy | Yes, Buddy hose | 48–110 hours | 3–6 hours |
| Big Buddy | Yes, one or two tanks | 24–108 hours (two tanks 48–216) | 1.5–6 hours, low and medium only |
| Buddy FLEX | Yes, Buddy hose | 36–72 hours | 1.5–3.5 hours |
| Hunting Buddy | Yes, Buddy hose | 36–72 hours | 1.5–3.5 hours |
| Little Buddy | No, 1 lb cylinder only | Not offered | About 5 hours |
The arithmetic backs these up. At 9,000 BTU an hour, 432,000 BTU lasts 48 hours, which matches the Portable Buddy’s figure on high.
The Big Buddy has one more reason to go big. On a single 1 lb cylinder it runs on low and medium only, and Mr. Heater says its 18,000 BTU setting needs two cylinders or a larger tank, as the Big Buddy review explains.
Picking the hose, and when you need a filter
Mr. Heater sells several hoses for the Buddy line, and they differ in one way that matters. Some need an inline fuel filter and some don’t.
- F273704, 10 ft Buddy hose
- No filter needed; Mr. Heater says its rubber lacks the oily plasticizers
- F273701, 5 ft hose
- Needs the F273699 fuel filter, replaced every year
- F273702, 12 ft hose
- Needs the F273699 fuel filter, replaced every year
Mr. Heater describes the filter as an oil trap. Oily residue that reaches the heater is one more suspect when a pilot starts acting up, which the guide on a pilot that won’t stay lit works through.
If you don’t want to track a filter, the F273704 is the simple choice. If you already own a 5 or 12 ft hose, fit the filter as its instructions show and put a new one on each fall.
The tank stays outside
This rule has no exceptions. Mr. Heater’s manuals forbid bringing a refillable propane cylinder inside, and they cap the remote tank at 20 lb, since Mr. Heater tests the heaters up to that size and doesn’t recommend larger ones.
Stand the tank upright on the ice beside the shelter, away from where you walk and drill. Bring the hose in under the skirt or through a low gap, so the fabric doesn’t pinch it and the door can’t catch it.
Route the hose well away from the heater face. The Portable Buddy needs 30 in clear overhead and 24 in clear in front, per its manual, and the ice shelter safety rules cover clearances and venting in full.
Never run the Mr. Heater MH15T, or any tank-top heater, inside a shelter. Mr. Heater labels it for outdoor use only, and it puts the tank in the shelter with you, which breaks the rule above.
Hooking up and leak-checking
Do the tank end of the job outside, with the heater off and nothing lit nearby. The order below keeps gas out of the hose until every joint is tight.
- Turn the heater control off and close the tank valve
- Connect the hose to the tank outside, snug on the fitting
- Connect the other end to the heater, with the filter fitted if your hose needs one
- Open the tank valve slowly
- Brush soapy water on every joint and watch for bubbles
- If you see bubbles or smell gas, close the tank valve and fix the joint before lighting
Never hunt for a leak with a flame. Look the hose over for cracks and stiff spots each trip, because cold rubber stiffens and a damaged hose has no place near a heater.
Cold-weather habits for the tank
A 20 lb tank fades in deep cold too, only much later than a small cylinder. Keep it out of drifts, and on a bitter day expect a nearly empty tank to struggle sooner than a full one.
Keep the tank away from any heat source, and never warm it with a flame or a heater. When you finish fishing, close the tank valve, let the heater burn off the gas left in the hose, then turn the control off.
Leave the tank outside overnight, and disconnect it outdoors when you pack up. Store it upright in shade at home, out of the sun and away from living space.
Which heaters this setup suits
The Portable Buddy takes a Buddy hose, and so do the Big Buddy, the Buddy FLEX and the Hunting Buddy. The Little Buddy doesn’t, since its manual covers 1 lb cylinders only, so it is a poor match for long days below zero.
The Portable Buddy or Big Buddy comparison helps you choose between the two hose-ready heaters most anglers buy. Shelter size decides the rest, and sizing the heater to your shelter matches heaters to flip-overs, hubs and shacks.
Our ice fishing heater comparison puts all five side by side, and the sizing and run time section shows the numbers in one place. If you already run a big hub, go straight to the Big Buddy card.
If you plan to run a tank all winter
The Big Buddy gains the most from a 20 lb tank, because its top setting needs more fuel than one small cylinder gives. Pair it with an F273704 hose and keep the tank outside, and it can heat a big hub through a long day, though it is heavy to haul.